Clutch & Flywheel Holding Tool

Maximum Opening 146mm (120mm Locked)

Perfect for holding the clutch boss or front sprocket when trying to undo or tighten the centre nut.

The back of the arms have 2 pegs which are for locating in the flywheel holes again for undoing the flywheel nut and also for holding the crank whilst you undo the primary nut.

If you are rebuilding an engine, there are 4 engine nuts that need to be removed in a specific order -

1. Front Sprocket Nut

Put the bike is 1st gear and clamp this tool to the clutch boss, you will then be able to remove this nut quite easily. If you are removing the sprocket nut without rebuilding the engine then this tool will hold the sprocket.

2. Clutch Centre Nut

Clamp the tool to the clutch boss and remove the nut

3. Primary Drive nut

Locate the pegs on the rear of the tool in the holes in the flywheel, you have to be careful on the TY80 to avoid catching the magnets, then clamp shut and remove the primary drive centre nut, right side of the engine as you are sitting on it

4. Flywheel nut

Whilst the tool is still clamped to the flywheel you will be able to remove the centre nut and extract the flywheel using the flywheel puller we have listed. Before applying the extractor don't forget to remove the spring and flat washer from the flywheel. DON'T attempt to remove the flywheel with a hammer and tyre lever all you will do is wreck the end of the crank and the flywheel will still be on.

You will get the best results if the engine is still in the frame with the barrel and piston still in place, the engine won't roll about all over the bench.

For reassembling the engine do the above in reverse order, i.e

Flywheel nut

Primary nut

Clutch nut

Sprocket nut

Here endeth the lesson for today!

Prices include VAT at the standard rate - VAT will be removed at basket/checkout for international & Channel Islands orders

Postage prices are charged by weight and this can be checked at any time by following the instructions below.

Add item(s) to your basket and then click the basket link that appears in the shopping basket box top right ↗↗.

This will take you to your shopping basket where you select you shipping country and the postal charge for your item(s) will be displayed.

Please remember that you are not committing yourself to buy the item(s) until you complete checkout. Even then, if you change your mind, no problem we’ll just delete it!

For details of how to pay us please click link below

HOW TO PAY US

Buyers outside the UK get 16.66% discount on published prices, excluding postage. This is removed once you enter the destination country at the checkout

You guys don't have to pay the vat!